This is tutorial number 1 from our series of Arduino tutorials and in this part I will talk about blinking an LED using the one already available on the Arduino Uno board or using an external LED to ...

It is a pretty common first project to use an Arduino (or similar) to blink an LED. Which, of course, brings taunts of: you could have used a 555! You can, of course, also use any sort of oscillato… ...

Here’s a no-PCB Arduino that doesn’t obscure the DIP footprint of the AVR chip. It’s built on an ATmega88 chip, and includes a programming header, reset button, a couple of filter… ...

Setup 1. Run Arduino. 2. Open the LED blink example sketch: File > Examples > 1.Basics > Blink. You should see a window like in Figure 2. 3. Choose Tools > Board, then select your board, like in ...

Before opening the Arduino software, wire up the Arduino according to the circuits page using the 8MHz minimalist breadboard circuit but with a 10k pull-up resistor on the reset pin (physical pin 1).

Arduino is the go to board for most folks looking for an introduction to microcontrollers. That's largely thanks to its sizable community, ease of use and surprising versatility. But, there is one ...