That Arduino would be getting into 3D printing is almost a no-brainer ... The printer itself is only a 310 x 330 x 350 mm box while the printing area is naturally smaller at 140 x 100 x 100 ...

Arduino already has a niche within the maker and hackerspace community for its microcontrollers, which is an overlapping user base with 3D printing. The official presentation of the Materia will ...

Arduino, maker of the open source hardware platform of the same name, is teaming up with a startup called Sharebot to sell a 3D printer for about $1,000. Announced today, Materia 101 will be ...

Who has created and 3D ... printing with wafer thin walls. However it will produce a robust system that people may like to refine themselves. “ For more information and to build your very own ...

If so, then you might be interested in this project using Arduino. My goal with this project was to be able to dynamically know the filament status during the 3D printer operation. I developed this ...

There are some exceptions, but most 3D printers run on either an 8-bit Arduino or some Arduino variant ... most of the functions of traditional 3D printing firmware. It communicates with the ...

By harnessing the power of 3D printing, servo motors, and Arduino programming, you’ll create a robotic arm that responds to your commands through a sophisticated software interface, allowing for ...

It's a solution that's only become possible with the converge of 3D printing, the massive popularity of microcontrollers like the Arduino Due, and falling prices for robotics components.