4. Connect the breadboard rails to Arduino GND and +5V, and then check that your setup matches that of Figure 10-3. Mounting the Laser For this project, I’ve attached the servos to a pan-and ...

Looking for practical Arduino projects? This guide shows how to control a relay from your smartphone using an Arduino Uno — ...

Before opening the Arduino software, wire up the Arduino according to the circuits page using the 8MHz minimalist breadboard circuit but with a 10k pull-up resistor on the reset pin (physical pin 1).

Arduino .INO-format sketches can be ported over to Electron, but not without some changes; the I/O port labeling is different to some degree, and there's not a direct correlation of libraries.

For those less experienced folks looking to move their Arduino projects to more permanent installations, this is just for you! [Martyn] Posted a three part series, VeroBoardUino, over at his blog a… ...

Arduino is the go to board for most folks looking for an introduction to microcontrollers. That's largely thanks to its sizable community, ease of use and surprising versatility. But, there is one ...

Here’s a no-PCB Arduino that doesn’t obscure the DIP footprint of the AVR chip. It’s built on an ATmega88 chip, and includes a programming header, reset button, a couple of filter… ...