Our project is infact an Arduino with Serially Interfaced MAX7219 Operates an 8X8 LED Matrix to display a heart pattern. The MAX7219 IC is a serial input/output common-cathode display driver that ...

1 string of 50 addressable RGB LED lights 1 Arduino 1 micro-USB cable 1 9-volt battery holder with a switch 1 9-volt battery 1 set of three-pin JST SM Plug and Receptacle Cable Set Solder ...

This is a simple 0 to 9 counter circuit constructed using Arduino! Here, a common cathode 7-segment LED display is connected to Arduino for displaying the digits. The code (Arduino sketch) allows push ...

A Light Emitting Diode (LED) should light up once the Arduino has power and after a second or so, an LED on the board should start slowly blinking. The image below points out these LEDs on the board.

All the info you need right here ✦ In this occasion I'll make a lighting system to be controlled remotely from my rc using ...

To actually power and control the entire circuit, [Martyn] used an Arduino loaded up with a program based LedControl library makes programming the spedometer a snap.

Arduino has shrunk the UNO R4 with the Arduino Nano R4 board equipped with the same 48 MHz Renesas RA4M1 32-bit Arm ...

The UDOO has the same pins as the Arduino DUE, as well as the DUE's ARM SAM3X processor, which is dedicated to the GPIO pins. Android 4.0.4 or Linux (Ubuntu 11.10) runs on a second processor, a ...