Description: Using an Arduino or a micro controller we can generate cool looking patterns with an led strip with addressable LEDs. In this case I'm using an Arduino uno (clone board) and a strip of ...

This product is courtesy of It was super easy to make this mobile tracked platform and radio-controlled useful for building ...

I made this Arduino project that allows to turn ON and OFF LEDs using a cheap IR remote control as a preparation for the next big step: disassemble my girlfriend’s chinese LED lamp and replace its ...

This is a where a Power Mosfet comes in. With the help of the Power Mosfet, we can use the low voltage output from the Arduino ports to control high voltage/current loads -the popular “12V LED strips” ...

Like almost all Arduinos, has a built-in led – the green one on the left in the photo. And it has a pair of yellow leds – called TX and RX – to indicate traffic on the serial bus. Except, on the Micro ...

Using an IRFZ44N, I made a simple LED driver and used an Arduino Uno directly. Remember the Arduino pins go up to 5V and I used the fade example that generates PWM out of the box.

This setup allowed [Alex] to control all 128 LED’s with just seven bits, but it was too slow for him. His solution was to control the multiplexers with counter IC’s.

The mod works using a MAX7219 chip and Arduino Uno ATmega328 board, which control the two 8×8 LED matrixes making up the eyes. Each matrix is wired up to the MAX2719 chip–expect a lot of cables ...

Arduino continues to impress as a platform for makers. For instance, Plum Geek Robotics has developed a DIY programmable light - with the oft-stated intention of teaching young people - the Plumduino.