The wiper of the 10K potentiometer is wired to A0 of Arduino (5V-A0-GND), while anode (A) of the test LED is linked to D5 through a 220Ω-470Ω resistor and cathode (K) to GND. #include ...

But there are really just the two speeds with the current programming. Inside the cool laser-cut box is an Arduino Uno and a 9V battery, plus a current-limiting resistor and the all-important buzzer.

In this experiment we are going to use a element called photoresistor. This sensor allows us to interact with the external environment, through intensity of light. The photoresistor is based on light ...

It is a pretty common first project to use an Arduino (or similar) to blink an LED. Which, of course, brings taunts of: you could have used a 555! You can, of course, also use any sort of oscillato… ...

Making a servo tester using an Attiny85 micro chip, Attiny45 also works for this project. This diy servo tester is as good as ...

With two LEDs in series, the prior example becomes (9 – 3.1 – 3.1)/0.02 = 140, so you could use one 150-ohm resistor for every two LEDs. Mark evenly spaced spokes a few inches from the rim of ...

The mod works using a MAX7219 chip and Arduino Uno ATmega328 board, which control the two 8×8 LED matrixes making up the eyes. Each matrix is wired up to the MAX2719 chip–expect a lot of cables ...