Here’s a no-PCB Arduino that doesn’t obscure the DIP footprint of the AVR chip. It’s built on an ATmega88 chip, and includes a programming header, reset button, a couple of filter… ...

Before opening the Arduino software, wire up the Arduino according to the circuits page using the 8MHz minimalist breadboard circuit but with a 10k pull-up resistor on the reset pin (physical pin 1).

Digi-Key Electronics has signed a worldwide distribution agreement with LogiSwitch, makers of the Arduino-friendly NoBounce line of ICs and switches. The company writes: LogiSwitch’s adaptive NoBounce ...

4. Connect the breadboard rails to Arduino GND and +5V, and then check that your setup matches that of Figure 10-3. Mounting the Laser For this project, I’ve attached the servos to a pan-and ...