When using the Arduino as an ISP programmer you must specify the speed, using ‘-b’. That value is set in the Arduino sketch and should be 19200 by default.

Turning an Arduino of virtually any sort into a simple AVR 6-pin ISP programmer is old hat. But when Atmel came out with a series of really tiny AVR chips, the ATtiny10 and friends with only six pi… ...

Connect the programmer with your Arduino compatible board and start uploading the Arduino boot loader or upload your sketch. No drivers are needed, just select ‘Arduino as ISP’ from the IDE ...

Your Arduino UNO board (here used as a programmer) If you go through the Arduino IDE you can see an example sketch called “Arduino as ISP”. If you upload this code to your Arduino, it will basically ...

“The Arduino ISP is an In-System-Programmer that is used to program AVR microcontrollers. You can use the Arduino ISP to upload sketches directly on the AVR-based Arduino boards without the need ...