Below, you can see the circuit diagram used in this project. The system is powered using a 7.2V 18650 battery, which is connected to the Arduino's power input (Vin). The Arduino then supplies 5V to ...

Step-by-step guide on designing and programming a custom I2C slave sensor device using Arduino.

CardPlayer.com is the world’s oldest and most well-respected poker magazine and online gambling guide. Since 1988, Card Player has provided poker and casino players with poker strategy, news ...

Push Buttons (x2): 6x6mm tactile buttons, normally open, used for user input ... and circuit connections. Jumper Wires (Required): Male-to-male and female connectors for wiring components. Power ...

This work is motivated by the EnviroDIY community vision to create an open source hardware and software stack to deliver near real time environmental data from wireless sensor ... Arduino Zero), the ...

Abstract: This paper proposes a pedestrian localization technique using a wireless sensor network. An unknown input observer (UIO)-based Kalman filter and UIO-based ...

While developing a vacuum system used for homemade PVD sputtering aparatus I felt the need of a simple and cheap vacuum gauge that can measure pressures as low as 1 Pa. I was not able to find online a ...

After a theoretical analysis, the circuit was validated both in static and dynamic conditions using a fiber Bragg grating (FBG) sensor, which was subjected to temperature variations for static testing ...