My goal with this project was to be able to dynamically know the filament status during the 3D printer operation. I developed this project by mixing design, 3D printing, electronics, software, and of ...

An Arduino Uno R3 has been used to monitor the charging levels, temperature and other statistics within the rail. Watch the videos below to see the DIY railgun in action firing projectiles at ...

I usually make a quick servo tester on a breadboard and use the serial monitor in the arduino IDE to get the servo positions, ...

It’s a small, cheap, but still relatively capable soldering robot built out of a 3D printer. This project is a solution to the development hell of the OpenScan project.

Although we tend to think of 3D printers as high-tech toys, most of them are not especially powerful in the brain department. There are some exceptions, but most 3D printers run on either an 8-bit … ...

“Lite3DP is a micro 3D printer that utilizes high-print-quality, virtually-silent MSLA technology. It’s the first of its kind to be based entirely on Arduino, is open source, and comes in an ...

A DIYer has pieced together a railgun of 3D printed pieces and other parts. The 3D printed prototype made by the U.S Navy is considered legit.