Plug the RFID module into the breadboard with enough space around it. Connect the VCC pin to the Arduino's 3.3V (not 5V), and GND to the ground rail. For the data connections, wire SDA to Pin 10, SCK ...

FOR years, lecturer Dr Mehran Behjati and his wife would spend their weekends outdoors, taking to the bike trails and cycling ...

The devilish metal, when ingested through the drinking water, can be deadly. It is, therefore, crucial not to let it go ...

The demonstration design uses the ams OSRAM AS6212 temperature sensor and STMicroelectronics LIS2DW12 accelerometer boards ...

Hi, I'm Bill. I'm a software developer with a passion for making and electronics. I do a lot of things and here is where I ...

You can get just about any gear reduction you want using conventional gears. But when you need to get a certain reduction in a very small space with minimal to no backlash, you might find a wave ...

Elecrow hit Kickstarter with an electronics learning lab-in-a-box based around the Raspberry Pi. A 2nd generation crammed the lab into a laptop form factor. The CrowPi 3 "playground for programming, ...

RA2L2 low-power MCUs are the industry’s first MCU to support USB-C Revision 2.4 with 15W CC detection, USB FS, CAN, I3C, and low-power UART.