Plug the RFID module into the breadboard with enough space around it. Connect the VCC pin to the Arduino's 3.3V (not 5V), and GND to the ground rail. For the data connections, wire SDA to Pin 10, SCK ...

RA2L2 low-power MCUs are the industry’s first MCU to support USB-C Revision 2.4 with 15W CC detection, USB FS, CAN, I3C, and low-power UART.

Elecrow hit Kickstarter with an electronics learning lab-in-a-box based around the Raspberry Pi. A 2nd generation crammed the lab into a laptop form factor. The CrowPi 3 "playground for programming, ...

What could happen when you open-source a hardware project? No, seriously. I hold a fair few radical opinions – one is that ...

4 and 19 pins are used to adjust the display contrast through a resistor. I use a 1 Mega Ohm variable resistor. Acceptable contrast ~270kOm.

👨🏻‍💻 Codes in ".ino" programming language (arduino UNO) using arduino with 2-wire lcd 🔌 - davifernandesm/Arduino_Lcd ...

Hi, I'm Bill. I'm a software developer with a passion for making and electronics. I do a lot of things and here is where I ...

Hi, I'm Bill. I'm a software developer with a passion for making and electronics. I do a lot of things and here is where I ...

With a sub-$1,000 price, exceptional quality, and innovative resin management features, the Anycubic Photon Mono M7 Max is a ...

(Hint: there’s no Arduino-provided code involved; hardware registers and the __asm keyword show up.) If you learned embedded programming in an earlier era, this will probably seem glaringly obvious.

Linux: the ultimate Windows 10 upgrade? The bad news: Windows 10 is definitely going end of life this year. The good news: these Linux distros are ready and waiting to take advantage. APC tells ...