but since this post is about “interfacing an arduino with a serial lcd controller”, i’m quite disappointed. old lcd panels in my junk box: 4. lcd panels with serial controller: none. Report ...

It can be done, if you don’t mind (at least) tenfold bit rate reduction. If you set the uart to 8,N,1, than you know that long strings of back-to-back characters will have a 10 between the ...

The V0 (also labelled as VEE) connection is for contrast control, and a potentiometer (10K) is usually attached to this terminal. Normally, the R/W terminal is tied to ground. For backlighting purpsoe ...

Once you have finished the soldering work , get four jumper wires and connect the LCD module to your Arduino as per the instruction given below. (lcd display to arduino wiring) Arduino Setup. For this ...

Hi, I'm Bill. I'm a software developer with a passion for making and electronics. I do a lot of things and here is where I document my learning in order to be able to inspire other people to make ...