In the Discord channel was mentioned that the I2C bus does not work for the STM32 board in Arduino mode. There is more than one problem: The local files for the I2C LCD display with "Wire2" do no ...

The Waveshare 1.69-inch IPS touch LCD is a 1.69-inch rounded display with 240×280 resolution and a 262K color range. The display driver (ST7789V2) and touch controller (CST816T) are integrated ...

The device supports programming through various IDEs, frameworks, and languages including the Arduino IDE, the Espressif IDF, PlatformIO, and MicroPython. Additionally, both modules are equipped with ...

The circuit’s core revolves around the Arduino Nano (board1), an I2C LCD module (module2), a DHT11 humidity and temperature sensor (S1), jumper wires, a breadboard, a piezo buzzer, and additional ...

When there is garbage like that, the host and the LCD have lost nibble sync. i.e. the LCD is creating a byte from one nibble of one byte and on nibble from the next byte. A nibble was either lost or a ...

The 16x2 LCD can also be interfaced with Arduino without using an I2C module. Connect the D2 & D3 pins of Arduino to both the ends of Zig-Zag wire and connect the handle wire to the GND pin of Arduino ...

FM transmitters/receivers are among the top favorite circuits of any electronic enthusiast. In this article/video, I have introduced a complete digital FM receiver design that has equipped with an LCD ...

In this Arduino I2C tutorial, we will use I2C communication between two Arduino boards and send (0 to 127) values to each other by using a potentiometer. Values will be displayed on the 16x2 LCD ...

Snap Programming Last Updated: 7/27/18 This Arduino module takes past circuits and codes, and applies them to a new program called Snap4Arduino. Snap4Arduino allows us to program an Arduino board in ...