News

Taste The Code. How to Use Rotary Encoders and Interrupts With Your Arduino Projects. Posted: June 10, 2025 | Last updated: June 13, 2025. Hi, I'm Bill.
As usual, the rotary encoder has three pins. The ‘data’ pins (A-B) are wired directly to pins 1 and 8 of the MX8733 chip. I lifted off the rotary encoder from the circuit board as it was the only ...
Adding Arduino to your rotary encoder. Now that your rotary encoder hardware is up and running it’s time to tell your Arduino what to do with the encoder signals. There are the two basic ways to read ...
It is amazing how many Arduino programmes for decoding rotary encoders start with something like: "I looked at all the available rotary encoder sketches. About Us; Contact Us; ... // Encoder 1 pin A ...
“Roendi (Rotary Encoder with Display) features a STM32L433 MCU, 1.28″ TFT round display and a Alps Alpine 15Pulses/30Detent encoder. It can be programed either using ST-LINK/V2 or Arduino IDE ...
We’re digging these daisy-chainable encoders built by [fattore.saimon]. Each module consists of a rotary encoder attached to a PCB with a PIC16F15386 on the back. As we’ve covered in the past… ...
If you’ve been stuck on a project that uses a rotary encoder because you’ve run out of pins, this novel approach may help you get un-stuck. It’s a pretty impressive feat of circuit design to ...