As I've experimented and played with a lot of different sensors, I've discovered that these basic devices can be built for ...

Home Assistant is a fantastic software suite that can be used to integrate practically anything you can think of into your ...

Core int read () reads both the temperature and humidity from the sensor. Can be called at most once per second, otherwise it will return CHT832X_ERROR_LASTREAD Return value should be tested and be ...

Arduino Nicla Sense Env is a new sensor module with temperature, humidity, and gas (TVOC, NO2, O3) sensing that follows the launch of the Arduino Nicla Sense ME (Motion & Environment) module over ...

Measurements: BMP280: Temperature / pressure / approximate altitude BME280: Temperature / pressure / approximate altitude / humidity Three operation modes: Normal mode: Continues conversion Forced ...

DHT22 Temperature and Humidity Sensor Module The DHT22 module has a total of 3 pins. And the DHT22 bare bone sensor has 4 pins. If we consider the module among three pins two of which are power pins, ...

On the software front, you’ll only need to change the libraries to Arduino_BMI270_BMM150 for the new IMUs and Arduino_HS300x for the new temperature and humidity sensor, and after that, I understand ...

Arduino & AHT10 Next, I wired up AHT10 sensor module and Arduino Uno as shown in the below hardware setup diagram. I also uploaded a simple test code to display sensor readings on the Serial Monitor ...

In this project, ESP-12E WeMos D1 Wi-Fi Uno based ESP8266 shield for Arduino-compatible board and Ubidots website platform are used for sending email or SMS alerts for temperature and humidity ...